What drill bit to use to mount the outdoor mount

jkj22908 — Mon, 24 Apr 2017 15:46:58 GMT

Been on the phone for 15 minutes. Bought the indoor/outdoor mount which included zero instructions.

All I need is the drillbit to use to mount this stupid thing and not a single person in their support knows.

What has everyone else used? I need to install the plastic anchors.

Re: What drill bit to use to mount the outdoor mount

TomMac — Mon, 24 Apr 2017 15:47:20 GMT

If you need to install plastic anchors...

PUT the base of mount in the place you like, mark with a pencil / pen the mount hole locations.

You need a drill bit just very slightly smaller than the biggest diameter of the shaft of the anchors.

You drill the hole, use a small hammer to pound the anchor flush to the level of the materal you drilled into ( or a normal hammer used lightly )

Place mount on top and use screw into anchors

i do recommend a temp mount first to insure location is good before permanent mount hole by duc tape or however.