topic Re: Doorbell motion sensitivity not good in Arlo Video Doorbell Wire-Free

Doorbell motion sensitivity not good

Bclifton — Sun, 13 Jun 2021 15:59:12 GMT

We have a very small front porch, and the video doorbeldoesn’t start recording until you’re literally on the front porch 5 feet away….our old camera used to start recording when someone was on the street. It picked up every car that went by. Is there any way to make the doorbell record from a distance? If not, this doorbell is very disappointing.

Re: Doorbell motion sensitivity not good

jguerdat — Mon, 14 Jun 2021 11:11:35 GMT

Have you changed the motion sensitivity setting in your modes and rules?

Re: Doorbell motion sensitivity not good

Bclifton — Mon, 21 Jun 2021 14:04:44 GMT

I did and it didn’t help

Re: Doorbell motion sensitivity not good

StephenB — Mon, 21 Jun 2021 14:57:24 GMT

@Bclifton wrote:
I did and it didn’t help

Is there anything blocking the IR sensors? Maybe clean the doorbell surface and see if that helps.

Re: Doorbell motion sensitivity not good

jguerdat — Tue, 22 Jun 2021 14:00:29 GMT

Just thought of this - did you remove the protective plastic sheet from the front of the doorbell when installing it?

Re: Doorbell motion sensitivity not good

Bclifton — Tue, 22 Jun 2021 18:45:38 GMT

I just checked, and yes it was removed. I just don’t understand why you have to be so close for the camera to start recording.

Re: Doorbell motion sensitivity not good

StephenB — Wed, 23 Jun 2021 11:06:04 GMT

@Bclifton wrote:

I just don’t understand why you have to be so close for the camera to start recording.

It should be able to detect motion out to 20-25 feet.

Have you confirmed the 5-foot distance limit with the motion detection test? Or are you just looking at the recordings?