topic Trying to install with angle bracket in Arlo Video Doorbell

Trying to install with angle bracket

joelwmson — Tue, 23 Nov 2021 22:51:34 GMT

After screwing the bracket to the wall, I can't get the doorbell to snap on. I've tried adjusting the screws both in and out and even tried smaller screws. It snaps easily on all off the bracket when it's not attached to the wall.

Clearly the bracket is being deformed by my installation.

Any ideas?

Thanks and best regards.

Re: Trying to install with angle bracket

StephenB — Tue, 23 Nov 2021 23:05:53 GMT

@joelwmson wrote:

Clearly the bracket is being deformed by my installation.

Another possibility is that the wires are taking too much space.

If it is the bracket being bent, then pretty much all you can do is loosen the screws.

Re: Trying to install with angle bracket

taser57 — Wed, 24 Nov 2021 21:18:15 GMT

I had problems getting mine to snap in place as well. Thought it might be the wires but then I added the extensions and it ended up fitting. I ended up finding part of my issue was the doorbell got turned around and the button was on the top not the bottom. Secondly make sure to push up from the bottom then in. All the sudden, it snapped in place.

Re: Trying to install with angle bracket

joelwmson — Thu, 25 Nov 2021 02:11:07 GMT

Thanks for the responses. A little more fussing and it snapped together.