topic Re: Fog setting off motion on pro 3 only in Arlo Pro 3

Fog setting off motion on pro 3 only

Iamspartacus8 — Sat, 23 Nov 2019 17:02:53 GMT

I have a mix of arlo pro, pro2 , ultra and just added a pro 3 . The pro 3 motion sensor constantly goes off due to fog. I have adjusted angle, cut down motion zones, reduced sensitivity , nothing works?

this am after a particularly foggy night I had 91 recordings of the mist. (Snow is coming soon)

by the way, it is only the pro3 that has this issue. Thanks

Re: Fog setting off motion on pro 3 only

jguerdat — Sun, 24 Nov 2019 14:26:38 GMT

None of my Pro 3s do this. Start by rebooting the base and remove the camera from Settings, My Devices. Resync. ANy better? If not, try swapping cameras around.

Re: Fog setting off motion on pro 3 only

JamesC — Mon, 25 Nov 2019 17:40:38 GMT

Iamspartacus8,

Are you sure it's the fog and not something else at that location causing the trigger? You might try swapping the location of your Pro 3 and one of your other cameras (temporarily) to see if the issue follows the camera or the location.

JamesC

Re: Fog setting off motion on pro 3 only

damlkm — Sat, 16 May 2020 17:16:35 GMT

Mine does the same thing in fog. A recording every minute or two - it really is annoying. I've messed with the sensitivity settings, and that doesn't seem to do anything.

Re: Fog setting off motion on pro 3 only

jguerdat — Sun, 17 May 2020 14:26:21 GMT

Are you changing the sensitivity setting in your modes and rules?

Re: Fog setting off motion on pro 3 only

damlkm — Mon, 18 May 2020 20:15:24 GMT

Yes. I change the sensitivity in the modes and rules from 1 - 100 without any noticeable effect.