<?xml version="1.0" encoding="UTF-8"?>
<rss xmlns:content="http://purl.org/rss/1.0/modules/content/" xmlns:dc="http://purl.org/dc/elements/1.1/" xmlns:rdf="http://www.w3.org/1999/02/22-rdf-syntax-ns#" xmlns:taxo="http://purl.org/rss/1.0/modules/taxonomy/" version="2.0">
  <channel>
    <title>topic Arlo Pro 2; Planning For Power Outages in Arlo Pro 2</title>
    <link>https://community.arlo.com/t5/Arlo-Pro-2/Arlo-Pro-2-Planning-For-Power-Outages/m-p/1666579#M20298</link>
    <description>&lt;P&gt;I would use a UPS for the base - a small one would do fine if the base is the only thing connected. If not too far away, a long extension cord to the existing UPS may be possible.&lt;/P&gt;
&lt;P&gt;&amp;nbsp;&lt;/P&gt;
&lt;P&gt;A thumb drive is much easier and smaller than a hard drive to capture videos when the Internet is down. And a lot cheaper. A 16GB one would likely hold at least a couple of month's worth of videos for most folks.&lt;/P&gt;</description>
    <pubDate>Mon, 07 Jan 2019 22:40:45 GMT</pubDate>
    <dc:creator>jguerdat</dc:creator>
    <dc:date>2019-01-07T22:40:45Z</dc:date>
    <item>
      <title>Arlo Pro 2; Planning For Power Outages</title>
      <link>https://community.arlo.com/t5/Arlo-Pro-2/Arlo-Pro-2-Planning-For-Power-Outages/m-p/1666542#M20291</link>
      <description>&lt;P&gt;Hi,&lt;BR /&gt;&lt;BR /&gt;My parents (where the cameras are installed) had a power outage which was reoccuring every 15min for 6h's and then a couple of longer ones which were 3-4h each.&lt;BR /&gt;&lt;BR /&gt;I had to reset their basestation after the power outages even though all LEDs were lit and internet was working.&lt;BR /&gt;Now I was thinking of creating a more fault-tolerant solution in the future and I was thinking of the following:&lt;BR /&gt;&lt;BR /&gt;Currently I have a UPS connected to the router and the switch.&lt;/P&gt;
&lt;P&gt;&amp;nbsp;&lt;/P&gt;
&lt;P&gt;* Buy another UPS or move the Base Station where the existing UPS is, this will however degrade the connection from the station to the cameras since the current UPS / router / switch is inside a shelf inside a room under the stairs.&lt;BR /&gt;* Connect a 4G-modem to my router and setup as failover when the primary uplink dies&lt;/P&gt;
&lt;P&gt;* Connect an external harddrive to the basestation to cover for outages for both the primary and secondary uplink (i.e. "Internet")&lt;BR /&gt;&lt;BR /&gt;The cameras should be fine as long as the battery holds, all cameras are currently on AC-power so they do not drain the battery when there is power.&lt;/P&gt;
&lt;P&gt;&amp;nbsp;&lt;/P&gt;
&lt;P&gt;Anything else?&lt;BR /&gt;I'm guessing I could connect a UPS to every camera but thats not feasible or at least not something I would do as of right now.&lt;/P&gt;
&lt;P&gt;&amp;nbsp;&lt;/P&gt;
&lt;P&gt;Question:&lt;BR /&gt;Does the Base Station support / can power 2.5" HDDs that draw power from the USB-port or does it need a 3,5" HDD that draws power &lt;SPAN&gt;seperatly&lt;/SPAN&gt;?&lt;BR /&gt;&lt;BR /&gt;Thanks for your ideas!&lt;/P&gt;</description>
      <pubDate>Mon, 07 Jan 2019 22:40:30 GMT</pubDate>
      <guid>https://community.arlo.com/t5/Arlo-Pro-2/Arlo-Pro-2-Planning-For-Power-Outages/m-p/1666542#M20291</guid>
      <dc:creator>_TheSwede86_</dc:creator>
      <dc:date>2019-01-07T22:40:30Z</dc:date>
    </item>
    <item>
      <title>Arlo Pro 2; Planning For Power Outages</title>
      <link>https://community.arlo.com/t5/Arlo-Pro-2/Arlo-Pro-2-Planning-For-Power-Outages/m-p/1666579#M20298</link>
      <description>&lt;P&gt;I would use a UPS for the base - a small one would do fine if the base is the only thing connected. If not too far away, a long extension cord to the existing UPS may be possible.&lt;/P&gt;
&lt;P&gt;&amp;nbsp;&lt;/P&gt;
&lt;P&gt;A thumb drive is much easier and smaller than a hard drive to capture videos when the Internet is down. And a lot cheaper. A 16GB one would likely hold at least a couple of month's worth of videos for most folks.&lt;/P&gt;</description>
      <pubDate>Mon, 07 Jan 2019 22:40:45 GMT</pubDate>
      <guid>https://community.arlo.com/t5/Arlo-Pro-2/Arlo-Pro-2-Planning-For-Power-Outages/m-p/1666579#M20298</guid>
      <dc:creator>jguerdat</dc:creator>
      <dc:date>2019-01-07T22:40:45Z</dc:date>
    </item>
  </channel>
</rss>

