topic Re: attaching to siding in Arlo Pro

attaching to siding

MikeB560 — Mon, 01 May 2017 18:13:28 GMT

I have not yet bought a ARLO PRO. I have new siding on my house and do not want to drill holes into the siding for installation. What is the best way to install or attach the camera to siding without compromising or damaging the siding? Like to have something strong enough to hold it in place during high winds. Any suggestions?

Re: attaching to siding

shipoopi — Mon, 01 May 2017 18:44:57 GMT

I think if you're trying to attach it to stucco you might not have a choice. For a wood beam I'd say drilling a hole is the strongest but I can't say much for the fact that there is only 1 mounting screw on the camera base.

Re: attaching to siding

TomMac — Mon, 01 May 2017 19:25:03 GMT

I've had good luck with 3M molding tape ( double sided ) at the auto parts store...

Re: attaching to siding

MikeB560 — Mon, 01 May 2017 20:48:03 GMT

No, not attaching it to stucco. Attaching to vinyl siding.

Re: attaching to siding

STR3T — Tue, 02 May 2017 16:09:11 GMT

In the same boat...looking to attach to vinyl siding. Assume the Pro Mounts (sold separately) would work well, assuming the screws are long enough to hit a a stud (hopefully) or at least some plywood. But you'll also want to ensure you don't drill into any live wiring or plumbing...

Re: attaching to siding

STR3T — Tue, 02 May 2017 17:33:12 GMT

Don't see an "edit" function...

Can anyone confirm the length of the screws that come with the Arlo Pro mount?

https://www.arlo.com/en-us/products/arlo/outdoor-mount.aspx#VMA1000

Re: attaching to siding

Hula_Rock — Tue, 02 May 2017 20:19:38 GMT

I used 3M outdoor mounting tape at one location, that camera has been upr for 2 years with no problems.

Re: attaching to siding

veener79 — Thu, 13 Jul 2017 01:49:21 GMT

Thanks for the tip. Wanting to install a camera by my patio door and there is no wood to mount to just siding.

Re: attaching to siding

katdu — Wed, 19 Jul 2017 17:28:10 GMT

This link does not tell the length of the screws that come with the Arlo.

Re: attaching to siding

katdu — Wed, 19 Jul 2017 17:30:34 GMT

Screws are defnitely not long enough to hit anything solid. Don't know how I will mount these cameras on my vinyl siding. No other place to mount them! ugh

Re: attaching to siding

jguerdat — Wed, 19 Jul 2017 19:57:42 GMT

I'd guess the screws are 1-1.5" long. Depending on how thick the foam board is behind the siding I think a 2-2.5" screw would be fine. I think that's what I used. Before permanently mounting, though, try double-sided tape to check positioning. And if the screws turn out to be too short, just remove them and use a longer screw of the same diameter.

Re: attaching to siding

veener79 — Wed, 19 Jul 2017 20:09:06 GMT

I just mounted 3 of my camera to my vinyl siding. I used the tape below. It states it will hold 15lbs. Did two strips on the back and that took up about 95% of the back.

http://www.homedepot.com/p/3M-Scotch-1-in-x-1-66-yds-Permanent-Double-Sided-Outdoor-Mounting-Tape-411DC-SF/100575385

They are holding up perfect so far. I need to move one because I put it too close to my flag and it trips a lot. So now I will not have to worry about filling in a hole if I would have used a longer screw.

Re: attaching to siding

katdu — Thu, 20 Jul 2017 13:54:18 GMT

Thank you so much. It looks like the tape will have to be my answer for at least one of my cameras. I made a tiny pilot hole in the siding and when it hit nothing I inserted a wire and it went in almost 5 inches before it hit anything solid and then I don't know what it's hitting. This part of the house is a front porch that was added later so who knows. Thanks so much for letting me know about the tape.

Re: attaching to siding

Hula_Rock — Thu, 20 Jul 2017 15:33:06 GMT

No Problem.... just check on it every couple of months. I was a little concerned about the tape since it was installed at a location with full direct South Texas sun/heat (8 hours a day). It has been fine for a couple of years now.

Re: attaching to siding

MG24 — Wed, 20 Dec 2017 17:04:27 GMT

I am looking to use the double sided tape to attach a camera to my siding, which mount did you use? The outdoor mount or the outdoor security mount? Thanks.

Re: attaching to siding

dfwald — Thu, 21 Dec 2017 22:08:12 GMT

I used the 3M outdoor double sided tape from Home Depot on all of my outdoor camera mounts and it seemed to hold for many months but recently one fell off. I then re-applied tape to it and bought Loctite Stik'n Seal outdoor adhesive to apply along the top half edge where it met the brick I was sticking it to. This water resistant adhesive along the edge together with the tape did the trick and now my mount should never come off. I'm using the dome mounts that come free with the cameras on brick.

Re: attaching to siding

DreamTeam — Wed, 27 Dec 2017 20:24:11 GMT

Just had a question about the 3M mounting tape - do you find that it is really secure? Just want to make sure no one can just grab the camera and run.

Thanks!

Re: attaching to siding

MrA2u1 — Sun, 31 Dec 2017 22:33:53 GMT

i am using 3M command tape. It's been up for amost a month now with no issues. FYI, its been under 20 degrees F for a few days now..

Re: attaching to siding

veener79 — Tue, 02 Jan 2018 01:43:56 GMT

Right now we have had nights and days staying below 0. Down to -15 at some points. The 3M is holding up great.

Re: attaching to siding

SteveMonty — Sat, 10 Feb 2018 12:36:01 GMT

I have vinyl siding in a location I want to put a camera. I'm going to try Phenoseal vinyl adhesive. Thought of command strips or something like that, but my Simplisafe door sensors use those. In winter, the sensor aleays falls off of my garage door.