topic Re: Motion Detection in Arlo Pro

Motion Detection

dansta — Mon, 12 Jun 2017 16:08:25 GMT

Hello there,

I was wondering in terms of motion detection, is there any future planned updates to give you the ability to draw out a detection area? That way you could have a view of the road at the end of the driveway, but it wouldn't trigger until an object entered say the driveway, as an example.

From my understanding now, the camera will record upon detection of anything within its field of view, please do correct me if I am wrong as I am trying to research as much as possible before investing in this system.

Thanks

Re: Motion Detection

jguerdat — Mon, 12 Jun 2017 16:29:44 GMT

AFAIK, there's no plans to have zones for the wireless cameras. The Q cameras do have this due to a different detection scheme. I use a small piece of black plastic electrical tape to mask the PIR detectors from unwanted areas of detections. Lo-tech but it works.

Re: Motion Detection

dansta — Mon, 12 Jun 2017 16:37:21 GMT

any pictures you could show me of this solution? I guess its a great low tech interm thing but having such a programmable area for detection would be pretty great.

Re: Motion Detection

jguerdat — Tue, 13 Jun 2017 00:44:02 GMT

I'll see if I can get a couple tomorrow. You may need to remind me.

Re: Motion Detection

jguerdat — Tue, 13 Jun 2017 14:15:53 GMT

Here's two different cameras - you'll have to wait for them to be approved. Ignore the cobwebs - they're gone now 🙂 :

Re: Motion Detection

dansta — Tue, 13 Jun 2017 15:07:14 GMT

thanks for that. I will have to look into implementing something of that nature also I guess.

Re: Motion Detection

dfwald — Thu, 22 Jun 2017 15:59:05 GMT

The motion detection has a max range so I highly doubt it would pick up traffic at the end of a driveway if mounted on a house unless the driveway is pretty short. If it does, you could always dial down the sensitivity and that could function as a defining of a detection distance.

Re: Motion Detection

Budman1 — Sun, 02 Jul 2017 19:41:21 GMT

My motion detector is set to 1% and I get messages every 2 minutes from both cameras. One is aimed at an empty front porch and one is aimed at the street 75 ft away. When it was on 80% it easily saw every car but missed the main part of the driving and only caugt the last 1/3 of the recording.

Now that it is on 1%, it just alerts every 2 minutes. and the other one also.

I am a novice.

Re: Motion Detection

jguerdat — Sun, 02 Jul 2017 21:50:51 GMT

Take the camera into a quiet room and let it sit pointed at a blank wall with no shadows moving. If it still does this, try reinserting the battery to reset it. Last resort is to swap at the store or open a case with support using the Contact Support link at the bottom here.