topic Re: Reset to factory setting in Features

Reset to factory setting

jcmesina — Mon, 03 Oct 2016 02:03:30 GMT

I deleted the factory all motion on rule by mistake. How do I reset my base station and camera to the original factory settings so I can start over?

Re: Reset to factory setting

TomMac — Fri, 17 Apr 2015 21:35:49 GMT

Perform a factory reset on your base station.

Push the Reset button (on the back of the base station) and the Sync button (on the side of the base station) for about 10 seconds or until all the LED lights on the base station blink amber. This procedure returns the base station to its factory settings. If your cameras were synced to the base station, you might need to sync the cameras again after the base station comes back online. For more information, see How Do I Set Up And Sync My Arlo Cameras?.

Re: Reset to factory setting

R_Lowe — Fri, 17 Apr 2015 23:59:30 GMT

You could maybe instead but certainly supplementally go to Settings/Base Station Settings, then click on the "RESTART" button at the very bottom of the right panel.

Re: Reset to factory setting

TomMac — Sat, 18 Apr 2015 12:26:26 GMT

R_Lowe wrote:
You could maybe instead but certainly supplementally go to Settings/Base Station Settings, then click on the "RESTART" button at the very bottom of the right panel.

I don't believe that will bring back the 'default modes' that were deleted