topic Re: Running Man Stays Grey Even When All Motion On is Selected in Features

Running Man Stays Grey Even When All Motion On is Selected

JCC60 — Mon, 03 Oct 2016 02:47:09 GMT

I have five cameras installed. I have "All Motion On" Mode set and I have identical rules set for each one.

Three of the running men are green, but two of them are grey and will not change to green no matter what I try.

I have tried deleting the rules for the 2 cameras and re-doing them & I have tried turning the modes on and off. Nothing seems to work.

Any ideas?

Re: Running Man Stays Grey Even When All Motion On is Selected

JCC60 — Thu, 22 Oct 2015 00:44:38 GMT

Nevermind. I figured it out. It was the type of problem IT guys refer to as a PICNIC.

Problem In Chair, Not In Computer.

Re: Running Man Stays Grey Even When All Motion On is Selected

jguerdat — Thu, 22 Oct 2015 13:04:02 GMT

Users are lusers...

😛

Re: Running Man Stays Grey Even When All Motion On is Selected

CGM — Tue, 27 Oct 2015 23:19:50 GMT

So What is the answer to this problem?

Re: Running Man Stays Grey Even When All Motion On is Selected

TomMac — Wed, 28 Oct 2015 00:41:53 GMT

the answer was operator error... prob; The MODE didn't have the camera toggles active

Re: Running Man Stays Grey Even When All Motion On is Selected

ruth929 — Mon, 07 Dec 2015 04:57:44 GMT

I have the same problem. Under "Cameras" tab in my Arlo log in site, all 4 of my cameras have a grey running man even though All Motion On is Selected. Can anyone help?

Re: Running Man Stays Grey Even When All Motion On is Selected

JCC60 — Mon, 07 Dec 2015 12:07:06 GMT

Go to Settings. click on "Modes" and then click on the pencil beside "All motion on" and then make sure that all of the check marks down the right side are clicked and green.