https://community.arlo.com/t5/Arlo-Audio-Doorbell/Backplate-for-doorbell/m-p/1652175#M564 <P>I had tried 3D printing one to provide some clearance for the existing doorbell wires.&nbsp; That didn't work out too well.&nbsp; Luckily, the holes for the existing doorbell were closer than the Arlo's and I ended up using some plastic washers for the needed spacing.&nbsp; Depending on your situation, you might want to consider getting a piece of aluminum trim and cutting it to size.&nbsp; Can you post a photo of your doorframe?</P> Tue, 20 Nov 2018 12:27:35 GMT RichLevow 2018-11-20T12:27:35Z https://community.arlo.com/t5/Arlo-Audio-Doorbell/Backplate-for-doorbell/m-p/1652131#M561 <P>I have the Arlo doorbell, but it's a different size to my old doorbell and I can see paintmarks and screw holes.&nbsp; Has anyone found a good doorbell backplate that looks good with their Arlo doorbell?</P> Tue, 20 Nov 2018 03:23:50 GMT https://community.arlo.com/t5/Arlo-Audio-Doorbell/Backplate-for-doorbell/m-p/1652131#M561 fordhamg 2018-11-20T03:23:50Z https://community.arlo.com/t5/Arlo-Audio-Doorbell/Backplate-for-doorbell/m-p/1652175#M564 <P>I had tried 3D printing one to provide some clearance for the existing doorbell wires.&nbsp; That didn't work out too well.&nbsp; Luckily, the holes for the existing doorbell were closer than the Arlo's and I ended up using some plastic washers for the needed spacing.&nbsp; Depending on your situation, you might want to consider getting a piece of aluminum trim and cutting it to size.&nbsp; Can you post a photo of your doorframe?</P> Tue, 20 Nov 2018 12:27:35 GMT https://community.arlo.com/t5/Arlo-Audio-Doorbell/Backplate-for-doorbell/m-p/1652175#M564 RichLevow 2018-11-20T12:27:35Z